12V-40V DC 10A PWM DC Motor Speed Controller with potentiometer maximum 400W*
We're forever being asked for a stripped down budget version of our controllers, and here it is!
Comes with an RC snubber to help protect your controller from indictive loads!
While it's not heavy on features, it has got what we look for first and foremost in controllers - reliability. Its also an insanely cost effective solution to smaller scale control requirements. At this price, its a real bargain!
Simply wire up your battery and motor and you're set.
No really, that's it. The 10k pot comes pre-attached, there's no on/off function - its always on when connected to power. Just wire everything in and its done.
It even has some built on protection - a simple, replicable fuse rated to 10A - easy to remove and easier to put in. Perfect for anyone who needs to limit current. Simply replace the fuse with a LOWER value fuse and you get some very effective current limiting - maybe not the most efficient, but you can't argue with results at this price!
Description:
Controls the speed of a DC motor with this controller High efficiency, high torque and low heat generation
With reverse polarity protection with high current protection
Voltage: DC 12v - 40V DC Control Power
consumption: 0.01 400W - Please note that this cannot run contuinously at 400W! that is the absolute maximum that it can handle.
Trying to run anything over a 200W motor will cause current spikes higher than the unit is capable of handling. You have been warned!
Static current: 0.02 A (Standby)
PWM Sampling rate: 0% -100%
PWM frequency: 3 kHz
Dimension (L x W x H): approx. 73 x 60 x 27 mm
Material: plastic, metal
